Fischer Nail anchor FNA II (Nail head) M6
by Fischer
KES 95
The fischer nail anchor FNA II 6 with nail head is made of zinc-plated steel. The FNA II is set in a time-saving manner in the push-through installation with just a few taps of the hammer. The installed FNA II expands automatically under load. The cone is then pulled into the expansion clip and expands it against the hole wall. Above all, the fischer nail anchor FNA II 6 with nail head is suitable for fixing fire protection boards, wire and nonious hangers in internal areas.
- Drill diameter: 6mm
- Min. drill hole depth for through fixings: 70mm
- Anchor length: 65mm
- Max. fixture thickness: 30mm
- Head-Ø: 13mm
- ETA-Approved
| UPC | 44116 |
|---|---|
| Model Number | 44116 |
| Drill hole Diameter (mm) | 6 |
| Anchor Length (mm) | 65 |
| SKU | 44116 |
Reviews
Description
Permission
- ETA-06/0175
- ETA-06/0175
- DoP 0235
Advantages
- The special active principle allows for a simple hammerset installation and, therefore, a short processing time.
- The extremely short anchor depth prevents reinforcement hits, and creates the conditions for a trouble-free installation.
- The optimised expansion clip ensures hold when placing in the drill hole, and prevents it falling out during overhead installations.
- The massive shaft cross-section guarantees a high load-bearing capacity, thus offering an extremely high level of safety.
- A range of head shapes allows for the fixing of wide-ranging fixtures, and for the ideal adaptation to suit the intended use.
